Why doesn’t my Reference Power (Tx) or Reference Power (Rx) change when I increase or decrease the power of a signal within my Transmitter? Is the power at my receiver front end different from the value in the Map tab? Should this menu be used for observing power measurements?
1 Like
Hi @Chris_Kiedrowicz, once the Reference Power (Tx) displayed in Skydel is set, it will not change even if the trajectory changes or even if you increase or decrease the power of the signal. The reference Power Rx change when the transmitter trajectory changes. The power at the receiver front end is the same at the value in the Map tab. Yes, you can use this menu to observe the power measurements for Rx.
Best regards
1 Like